One For All Remote Codes for Bush TV (Complete Guide)

by

Introduction: “One For All” is a leading brand of universal remotes known for its ease of use and broad device compatibility. If you want to control your Bush television, you’ll need to program your remote with the correct 4-digit code.

This guide provides a comprehensive list of programming codes for Bush devices and the correct, step-by-step programming instructions that are specific to the “One For All” brand.

One For All Codes for Bush TVs

Here is the list of codes for programming your One For All remote with a Bush Television. Please try them in the order they are listed.

Bush TV Codes:

  • 3133
  • 1155
  • 5641
  • 3153
  • 6425
  • 1426
  • 1354
  • 5214
  • 1432
  • 2223
  • 1121
  • 1236
  • 5152
  • 4214
  • 3542
  • 4131
  • 2614
  • 1322
  • 1131
  • 3544
  • 6224
  • 5222
  • 3162
  • 4254

How to Program Your One For All Remote for a Bush TV

“One For All” remotes use a unique MAGIC key for setup. Please follow these instructions exactly.

Method 1: SimpleSet (Direct Code Entry)

This is the fastest and most recommended method.

  1. Turn on your Bush TV manually.
  2. Press and hold the MAGIC button on your One For All remote until the LED indicator under the TV key blinks twice and stays lit.
  3. Enter one of the 4-digit codes from the list above.
  4. The LED indicator will blink twice and turn off.
  5. Now, point the remote at your TV and press the POWER button. If the TV turns off, the setup is successful. Turn the TV back on and test the VOLUME, MUTE, and CHANNEL buttons.
  6. If it does not work, repeat steps 2-5 with the next code on the list.

Method 2: Auto-Code Search

Use this method if none of the codes from the list work.

  1. Turn on your Bush TV.
  2. Press and hold the MAGIC button until the LED blinks twice and stays lit.
  3. Press 9 - 9 - 1. The LED will blink twice.
  4. Point the remote at the TV and repeatedly press the POWER button. The remote will cycle through its codes, sending a new signal each time you press the button.
  5. The moment your Bush TV turns off, STOP pressing POWER.
  6. Press and hold the MAGIC button until the LED blinks twice to save the code. Your remote is now ready to use.

Troubleshooting Tips

  • Problem: Some buttons work, but others don’t (e.g., POWER works, but VOLUME doesn’t).
    • Solution: This indicates a partial code match. You need to repeat the setup process (either Method 1 or 2) to find the next, more compatible code from the list.
  • Problem: The LED light does not respond when holding the MAGIC key.
    • Solution: Your batteries are likely dead. Replace them with a fresh pair and try again.

Conclusion: By following these specific instructions and using the provided list of codes, your One For All remote should now be fully paired with your Bush television. You can now enjoy the convenience of controlling your devices from a single, easy-to-use remote.

Leave a Comment